Wall coordinates

<< Click to Display Table of Contents >>

Navigation:  MDC >

Wall coordinates

The command for the advanced management of the coordinates of the section of the wall "Wall Coordinates" is activated only after having defined a type and having assigned the geometric quantities in wall geometry.


To change the coordinates you must assign them in the 4°and 5° columns of the grid, you must assign them both as shown in the figure.


coord_01 (1)



To facilitate the input system, it is possible to define a modification line as shown in the figure:


coord_01 (2)



The create command will create and display in the 4° and 5° column the coordinates to be assigned to the profile.


With the Reset command, you can return to the initial coordinates.






©  Geostru