Limit State of Liquefaction C. Hsein Juang 2006

<< Click to Display Table of Contents >>

Navigation:  Cenni teorici >

Limit State of Liquefaction C. Hsein Juang 2006


The limit state for liquefaction triggering is obtained using a neural network-based searching technique developed by Juang et al. 2000b. The technique involves the training of supervised feed-forward neural networks with the “full” database of case histories and its subsets or samples. The successfully trained neural network that generates the most accurate input–output relationship is adopted in the subsequent step for searching “data points” on the unknown boundary surface. Regression analyses of the searched data points, with some engineering judgment, yields the following empirical equation for liquefaction resistance:


CRR = exp(-2.8781 + 0.000309·(qc1N,m)1.81)    (1)




qc1N,m=stress-normalized cone tip resistance qc1N adjusted for the effect of “fines” on liquefaction thus, qc1N,m=K·qc1N.


The  stress-normalized cone tip resistance qc1N used herein follows the definition by Idriss and Boulanger 2004, although the difference between this definition and that by Robertson and Wride 1998 is rather small for the cases examined.


K is part of the regression model and expressed as:


K = 1 for Ic < 1.64 (2)

=1 + 80.06·(Ic − 1.64)·(qc1N)−1.2194                for 1.64 < Ic < 2.38

=1 + 59.24·(qc1N)−1.2194                        for Ic > 2.38


Both Ic and qc1N in Eqs. 2 are dimensionless. The term Ic in Eqs. 2 is a variant of the soil behavior type index defined by Lunne et al. 1997 and Robertson and Wride 1998, and updated in Zhang et al. 2002.
Although Ic was initially developed for soil classification, use of Ic to “gage” the effect of “fines” on liquefaction resistance is well accepted Robertson and Wride 1998; Youd et al. 2001;


As with any simplified methods that follow the general framework  by Seed and Idriss 1971, CRR is defined as the critical CSR that causes liquefaction for a given soil. Thus, it is essential

that the CRR equation has to be used along with the reference CSR equation. To use Eq. 1 for determination of CRR, the following cyclic stress ratio model must be used:


CSR7.5σ = 0.65·(σv/σ’v)·(amax/g)·rd·(1/MSF)·(1/Kσ) (3)




g= acceleration of gravity, which is the unit for amax;

rd= depth-dependent shear stress reduction factor dimensionless;

MSF= magnitude scaling factor dimensionless;

Kσ= overburden correction factor dimensionless for CSR.


In Eq. 3, CSR7.5σ, is the CSR defined by Seed and Idriss 1971 adjusted to the conditions of Mw moment magnitude=7.5 and σ=100 kPa. Such adjustment makes it easier to process case histories from different earthquakes and with soils of concern at different overburden pressures Juang et al. 2003. It should be noted that in this paper, the terms rd, MSF, and Kσ are calculated with the formulae recommended by Idriss and  Boulanger 2004;


The method C. Hsein Juang was implemented in software LIQUITER


More details